32
Setup Steps
Press the SETUP button, then press MODE repeatedly until the
desired setup step appears. Use the WARMER or COOLER buttons
to make selection. Press MODE to advance to the next step.
Press/hold MODE to go backwards to prior steps. Press SETUP to
leave the setup screens.
WARMER
COOLER
MODE
SETUP
IAQ Air Patrol
(Setup Step 74)
Select whether you want the Air Patrol features to be ENABLED or DISABLED. You may
always view the IAQ value regardless of this setting.
Air Patrol on if IAQ exceeds MODERATE Quality
(Setup Step 75)
This setting specifies at which IAQ category that Air Patrol actives, either MODERATE or
POOR. This step only appears if Step #74 is set to ENABLED.
Air Patrol Fan on Minutes
(Setup Step 76)
When IAQ value meets the level specified in Step #75, the indoor blower will run for the
length of time specified in this step, 5 to 60 minutes. This step only appears if step #74
is set to enabled.
Note: The auxiliary output can be programmed to turn on whenever Air Patrol
senses that the air quality has fallen to the level specified in step #75.
Set step #55 to AIR PATROL for this feature.
Skyport*
(Setup Step 77)
Set to ON to allow access to Skyport services or to OFF to not allow access to Skyport
services. Visit venstar.com for more information.
Local API*
(Setup Step 78)
Set to ON to allow third-party software to interface with your thermostat. Typically
used with home automation set-ups.
Show Clock
(Setup Step 79)
Select ON or OFF to have the time of day appear on the screen.
Show IAQ
(Setup Step 80)
Select ON or OFF to have IAQ measured levels of MODERATE or POOR show on the
scrolling display.
Press Fan To Clear All Messages
(Setup Step 81)
This feature allows the user to clear all current error messages from the display.
