11
How to use your thermostat
Press the
OFF | RUN HOLD TO SET
button to exit
Time Period Programming at any time.
OFF
RUN
HOLD TO SET
OFF
|
RUN
HOLD TO SET
Programming a Daily Schedule
Once the Set Program prompt appears the Mode button will step you through
the settings. When selecting a Mode for Unoccupied/Occupied, options are
OFF, HEAT, COOL, HEAT and COOL. These may be limited by the selection in
setup step #2, AVAILABLE MODES.
Set the Unoccupied Mode – Press the Warmer or Cooler buttons to choose the
mode for the Unoccupied period. The thermostat is in Unoccupied when the
Time Period Schedule is running and there is not an active Occupied period.
Adjust the Unoccupied Cool Setpoint – Press the Warmer or Cooler buttons to
adjust the Cooling setpoint for times when the thermostat is in Unoccupied.
Adjust the Unoccupied Heat Setpoint – Press the Warmer or Cooler buttons to
adjust the Heating setpoint for times when the thermostat is in Unoccupied.
Select the number of Occupied time periods – Press the Warmer or Cooler
buttons to choose the maximum number (up to 3 maximum) of Occupied time
periods in a day.
Select the Mode for the Occupied period – Press the Warmer or Cooler buttons
to choose the mode for the occupied period.
Adjust the Occupied Cool Setpoint – Press the Warmer or Cooler buttons to
adjust the Cooling setpoint for comfort.
Adjust the Occupied Heat Setpoint – Press the Warmer or Cooler buttons to
adjust the Heating setpoint for comfort.
The following steps determine when the Occupied period(s) will be active.
Enable Occupied 1 – Press the Warmer or Cooler buttons to enable (On) or to
disable (Off) Occupied 1 on Monday.
Adjust the Start Time for Occupied 1 – Press the Warmer or Cooler buttons to
adjust the start time for Occupied 1 on Monday.
Adjust the Stop Time for Occupied 1 – Press the Warmer or Cooler buttons to
adjust the stop time for Occupied 1 on Monday.
Upon pressing Mode after the above step; you will be prompted to Save and
Exit or Copy this Occupied schedule to another day.
To save and exit – Press the Program button.
To Copy Monday’s settings/schedule to Tuesday – Press Up and then Mode.
Press Mode again to copy the Monday Settings/schedule to subsequent days.
To Program Another Day – Press Down and then press the Mode button to
select the day to program. Repeat the above steps for each day you would like
to program.
