Start Up
Sentinel Kinetic MVHR Installation & Commissioning
15
Powering Up the Unit
Switching On
To switch the unit on:
1.
Switch on the power at the mains supply isolator feeding the unit.
2.
Following switch-on, the fan motors will start and the Remote Wired Control will display a series of start-up
screens, described below.
N.B. If you are intending to carry out work or maintenance inside the unit, switch off the power at the
mains outlet supplying the unit before you remove the covers.
Switching Off
To switch the unit off:
1.
Turn the power off at the mains supply isolator.
Wired Remote Control Display
Display
Normal Airflow
30%
Buttons
Four buttons on the Control Unit provide the controls for configuring and monitoring the unit.
Button
Function
Press to adjust settings and press to save settings.
Press to go to the previous screen or to increase a parameter value. Press
and hold for more than 2 seconds for fast scrolling.
Press to go to the next screen or to decrease a parameter value. Press and
hold for more than 2 seconds for fast scrolling.
Press to activate Boost mode. See page 16 for options.
Press and hold for 5 seconds to activate Purge mode. (Press and hold for 5
seconds to cancel Purge).
The main display is an LCD, see overview on page 21.
