IMPORTANT SAFETY INFORMATION
PLEASE READ THESE
INSTRUCTIONS CAREFULLY
BEFORE COMMENCING
INSTALLATION.
1. Do not install this product in areas where the
following may be present or occur:
• Excessive oil or a grease laden atmosphere.
• Corrosive or flammable gases, liquids or vapours.
• Subject to direct water spray from hoses.
• Ambient temperatures higher than 40°C and lower
than -20°C.
• Possible obstructions that may hinder access to or
removal of the unit.
2. All wiring must be in accordance with the current
IEE wiring regulations BS7671, or appropriate
standards of your country. Installation should be
inspected and tested by a suitably qualified person
after completion.
3. Ensure the mains supply (voltage, frequency and
phase) complies with the rating label.
4. The unit should be provided with a local double
pole fused spur fitted with a 3A fuse having a contact
separation of at least 3mm.
5. These units must be earthed.
6. Precautions must be taken to avoid the back-flow
of gases into the building from the open flue of gas or
other fuel-burning appliances.
7. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
8. Young children should be supervised to ensure
that they do not play with the appliance.
INSTALLATION GUIDANCE
1. The installer is responsible for the installation and
electrical connection of the sentinel system on site. It
is the responsibility of the installer to ensure that the
equipment is safely and securely installed and left
only when mechanically and electrically safe.
2. All regulations and requirements must be strictly
followed to prevent hazards to life and property, both
during and after installation, and during any
subsequent servicing and maintenance.
3. The unit’s condensate drain must be connected to
the building’s wastewater drainage system.
4. Certain applications may require the installation of
sound attenuation to achieve the sound levels
required.
5. The unit must not be connected directly to a
tumble drier.
6. The supply and exhaust valves must be fully
opened prior to commissioning.
7. The supply air must be drawn from the exterior of
the property.
8. The unit should be allowed to stabilise during
commissioning for a minimum period of 5 minutes
when changing between boost and normal speeds.
9. Ensure that the unit’s external grilles are a
minimum of 1500mm apart. The exhaust grille should
be located at least 600mm away from any flue outlet.
The inlet grille should be located 2000mm away from
any flue outlet.
10. This product and associated duct installation
should be carried out in accordance with the
domestic ventilation compliance guide.
Disposal
This product should not be disposed of
with household waste. Please recycle
where facilities exist. Check with your
local authority for recycling advice.
Summary of Contents for HR200V
Page 11: ......
