Installation
Kinetic MVHR Installation & Commissioning
8
Installing the Unit in the Opposite Orientation (LH Condensate)
Installing the unit in the opposite orientation involves
removing the front cover (and associated Control Unit
Panel), and the rear cover (and associated Cable Inlet
Plate), rotating the unit chassis and covers through
180 degrees and then re-attaching them.
This moves the condensate drain exit from the right
(rear) corner of the unit to the left (front) corner of the
unit, when viewed from the front (viewing the Control
Unit).
The arrow labels on the top edge of the Covers should
be correctly matched to the arrow labels on the top of
the Case.
1.
Remove the front and rear covers by unscrewing
the) fixing screws on both covers.
2.
Eight fixing screws on each cover.
3.
Remove the 2 screws and detach the Electrical
Cover from the front of the unit.
