background image

 

 

 

  

Installation and Wiring Instructions for the 

Lo-Carbon PureAir Home Positive Ventilation Unit. 

 

SAFETY AND GUIDANCE NOTES 

 

     IMPORTANT: 
     READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION 

 
 

1. 

DO NOT install this product in areas where the following may be present or occur: 

1.1.  Excessive oil or a grease laden atmosphere. 
1.2.  Corrosive or flammable gases, liquids or vapours. 
1.3.  Ambient temperatures higher than 40°C or less than -5°C. 
1.4.  Possible obstructions which would hinder access or removal of the Fan. 
1.5.  Relative humidity above 90% 
1.6.  Sudden ductwork bends or transformations close to the Unit. 

2. 

All wiring to be in accordance with the current I.E.E. Regulations, or the appropriate 
standards of your country and MUST be installed by a suitably qualified person. 

3. 

The fan must be provided with a 3A fused, isolator switch capable of disconnecting 
all poles, having a contact separation of at least 3mm. 

4. 

Ensure that the mains supply (voltage, frequency, and phase) complies with the fan’s 
rating label. 

5. 

The fan should not be used where it is liable to be subjected to direct water spray. 

6. 

This appliance can be used by children aged from 8 years and above and persons 
with reduced physical, sensory or mental capabilities or lack of experience and 
knowledge if they have been given supervision or instruction concerning use of the 
appliance in a safe way and understand the hazards involved. Children shall not play 
with the appliance. Cleaning and user maintenance shall not be made by children 
without supervision. 

7. 

Precautions must be taken to avoid the back-flow of gases into the room from the 
open flue of gas or other fuel-burning appliances. 

8. 

Children of less than 3 years should be kept away unless continuously supervised.  

9. 

Children aged from 3 to 8 years shall only switch on/off the appliance provided the 
unit is installed as intended for normal operation and they have been given 
supervision or instruction concerning safe use of the appliance and understand the 
hazards involved.  

10.  Children aged 3 to 8 shall not plug in, regulate and clean the appliance or perform 

user maintenance    

Caution - some parts of this product can become very hot and cause burns. 
Particular attention has to be given where children and vulnerable people are 
present. 
 

A. INTRODUCTORY NOTES

 

 

The Vent Axia Lo-Carbon PureAir Home is a positive input ventilation unit, designed to be installed in the loft of a 
dwelling to continually supply filtered fresh air into the building.  
 
The system consists of a fan unit, an 

optional

 heater unit and a diffuser with a short length of flexible ducting. 

 
The Lo-Carbon PureAir Home 

has two fully adjustable speed settings; ‘Trickle’ and ‘Energy Recovery’. These 

speeds are set during installation; there are 5 pre-set speeds or an option allowing the speeds to be chosen 
manually from 10L/s to 60L/s.  

Summary of Contents for Lo-Carbon PureAir Home FD

















Reviews: