5
Flexible ducting is supplied as standard. Ensure that this is pulled out and does not allow any moisture to collect; it
should be a smooth single curve to the grille. If the application requires a fixed 90 degree bend, straight ducting may
be used. See Spares and Accessories on page 11.
C. Hanging method:
The Lo-Carbon PureAir Home can be hung from a roof beam (Fig. 2). Fix the screw eye to a convenient roof beam.
Use the cord provided to loop through the eye and around the handle on the unit, there are various notches for the
cord to run through,
tie the two ends together using a suitable knot such as an over hand or fisherman’s knot.
Ensure that the route for the flexible ducting has gentle bends and that the duct cannot be crushed.
Fit the filters to the unit.
Please make sure that the filters are fitted correctly. This will ensure that all the fresh
air entering the dwelling has passed through the filter first.
Ensure that the screw eye is attached to the beam strongly enough and that the beam is in sufficient
condition to withstand the load. The unit weight is approximately 4 kg.
D. Floor mounting:
Attach the mounting legs to the unit, two per side.
Find a suitable location to fix the unit near to where the diffuser is to be located. Ensure that the route for the flexible
ducting has gentle bends and that the duct cannot be crushed Fig.3.
The legs and feet can be adjusted to suit ceiling joists of varying spans. Adjust the legs and feet so that the unit
spans over two joists. Secure the feet to the joists with screws, Fig.4. In the unlikely event that the legs cannot span
the ceiling joists affix the unit to a wooden board or two lengths of timber which can then be screwed to the joists.
Fit the filters to the unit.
Please make sure that the filters are fitted correctly. This will ensure that all the fresh
air entering the dwelling has passed through the filter first.
Fig. 4.
Fig.2.
Fig. 3.
Fig.2.
Filters
(See pg. 8)
