Open up the internal cover to access
The spirit level bubble
PANEL/CEILING/ INTERIOR WALL MOUNTING
1.
Cut a 105mm diameter hole.
2.
Remove the front panel by carefully
pulling it away from the fan. Loosen
the two self-retaining screws and
remove the inner grille by carefully
pulling it away from the housing.
3.
Using the built in spirit level bubble
as an aid.
Mark the screw centres
through the holes in the fan back
plate. Drill, plug and screw into
position. Attach ducting as required
for the installation.
4.
Wire the fan as described in
Section B-Wiring. Adjust any settings
as required (see Section C-Setup).
5.
After installation, ensure impeller rotates freely.
6.
Replace the inner grille and tighten the retaining screws.
7. Replace the front panel.
EXTERIOR WALL MOUNTING
1.
For wall mounting cut a 117mm diameter hole through the wall and
insert the wall sleeve. Slope the sleeve slightly downwards away
from the fan. Where necessary cut to length and cement both ends
into position flush with the wall faces.
2.
Fix exterior grille into position with the louvres positioned
downwards.
3.
Remove the front panel by carefully pulling it away from the fan.
Loosen the two self-retaining screws and remove the inner grille by
carefully pulling it away from the housing.
4.
Using the built in spirit level bubble as an aid.
Mark the screw
centres through the holes in the fan back plate. Drill, plug and
screw into position.
5.
Wire the fan as described in Section B-Wiring. Adjust any settings
as required (see Section C-Setup).
6.
After installation, ensure impeller rotates freely.
7.
Replace the inner grille and tighten the retaining screws.
8. Replace the front Panel.
