EN
2
Installation and Wiring Instructions for the Lo-Carbon Svelte Range of
Extractor Fans.
IMPORTANT:
READ THESE INSTRUCTIONS
BEFORE COMMENCING THE
INSTALLATION
DO NOT install this product in areas where the following may be present or
occur:
•
Excessive oil or a grease laden atmosphere.
•
Corrosive or flammable gases, liquids or vapours.
•
Ambient temperatures higher than 40°C or less than –5°C.
•
Possible obstructions which would hinder the access or removal of the
f
an.
SAFETY AND GUIDANCE NOTES
A.
All wiring to be in accordance with the current I.E.E. Regulations, or the
appropriate standards of your country and
MUST
be installed by a
suitably qualified person.
B.
The
f
an should be provided with a local isolator switch capable of
disconnecting all poles, having a contact separation of at least 3mm.
C.
Ensure that the mains supply (Voltage, Frequency, and Phase)
complies with the rating label.
D.
The
f
an should only be used in conjunction with the appropriate Vent-
Axia products.
E.
The fan should only be used in conjunction with fixed wiring.
F.
When the
f
an is used to remove air from a room containing a fuel-
burning appliance, ensure that the air replacement is adequate for both
the fan and the fuel-burning appliance.
G.
The
f
an should not be used where it is liable to be subject to direct
water spray for prolonged periods of time.
H.
Where ducted
f
ans are used to handle moisture-laden air, a
condensation trap should be fitted. Horizontal ducts should be arranged
to slope slightly downwards away from the
f
an.
I.
This appliance is not intended for use by pe
ople
(including children)
with
reduced physical, sensory or mental capabilities, or lack of
experience
and knowledge, unless they have been given supervision or
instruction
concerning use of the appliance by a person responsible for
their safety.
J.
Children should be supervised to ensure that they do not play with the
appliance.
K.
The
exterior
grille should be at least 2.3m above the ground to prevent
people from being able to access moving parts. If the
external
grille is
positioned between 0-2.3m from the ground,
p
lease use the Vent-Axia
wall kit as detailed below to ensure people cannot access the fans
impeller from the outside.
September 2017
Summary of Contents for Lo-Carbon Silhouette 100HT
Page 23: ...23...
