11126 McCormick Road, Hunt Valley, MD 21031 | 800-851-4965 | sales@ventev.com | ventevinfra.com |
Rev. 022822
25
3.13
Prevention of Electrostatic Charging
The Hazardous Environment Enclosure can build up electrostatic charge on its surfaces, so the following steps are to
be followed to reduce static charge build up:
Static charge build up should be reduced by:
•
Connecting the enclosure to a suitable earth point.
•
Cleaning off surface dust using a damp cloth.
•
Not installing into areas where high airflow can occur.
3.14
Additional Labels & Non-Metallic Materials
Additional labels may be fitted to the enclosure. Label material may be stainless steel or any other non-metallic
material. To prevent an electrostatic risk, non-metallic materials must only be cleaned with a damp cloth.
If non-metallic materials are used, consideration should be given to the following:
•
Control of environmental humidity to minimize the generation of static electricity.
•
Protection from direct airflow causing a charge transfer.
•
Touch with an insulation object.
•
Means to continuously drain off electrostatic charges.
