HE350 - Installation and Operation Manual
27
Place the door face-down on something soft like a cushion of rags or piece of carpet. Remove the old
gaskets from the door by pulling and prying it out with an old screw driver. Then use the screwdriver to
scrape the old gasket adhesive from the door. Now run a 1/4
"
(6 mm) bead of high temperature silicone in
the door gasket groove. Starting from the middle of the hinge side, press the gasket into the groove. Do not
stretch the gasket as you place it. Leave the gasket about 1/2
"
long when you cut it and press the end into
the groove. Tuck any loose fibres under the gasket and into the silicone. Close the door and do not use the
fireplace for 24 hours.
Location
Length
Dimensions
Door frame
65 ¾ " (167 cm)
Round 5/8" (1,59 cm)
Left door
18
"
Round 1/4
"
(0,64cm)
5.1.6
Replacing the Door Glass
The glass used in the HE350 is 5 mm thick of dimension 17.78" x 15.76" (45,16cm x 40,03cm) and tested to
reach temperatures up to 1400º F. If the glass breaks, it must be replaced with one having the same
specification. Contact your Ventis dealer to obtain a genuine replacement part (see “replacement parts”, in
appendix to get the proper part number).
WARNING
•
TEMPERED GLASS OR ORDINARY GLASS WILL NOT WITHSTAND THE HIGH TEMPERATURES OF THE
HE350.
•
DO NOT ABUSE THE GLASS DOOR BY SLAMMING IT AGAINST THR FIREPLACE.
•
DO NOT OPERATE THE FIREPLACE WITH A CRACKED OR BROKEN GLASS.
In order to replace the glass, use the following procedure;
1-
Remove the gasket
(E)
placed around the door frame
(G)
and its adhesive.
2-
Remove the12 glass retainers
(C)
held in place by 12 screws
(B)
.
3-
Remove the glass
(F)
and/or debris from the frame.
4-
Install the new window into the frame
(G)
and fasten it in place with the glass retainers
(C)
and the
screws
(B)
removed earlier.
5-
Handle the glass with care to avoid injury.
