Page 32
Installation and Operation Requirements - HES350
ENGLISH
7.2 Gasket
The glass gasket is flat, adhesive-backed, woven fibreglass. The
gasket must be centred on the edge of the glass.
1. Follow the steps of the previous section to remove the glass.
2. Remove the old gasket and clean the glass thoroughly.
3. Peel back a section of the paper covering the adhesive and place
the gasket on a table with the adhesive side up.
4. Stick the end of the gasket to the middle of one edge, then press
the edge of the glass down onto the gasket, taking care that it is perfectly centred on the gasket.
5. Peel off more of the backing and rotate the glass. The gasket must not be stretched during
installation.
6. Cut the gasket to the required length.
7. Pinch the gasket onto the glass in a U shape, all around the glass.
By following these instructions, the edge clearances are maintain.
7.3 Door
In order for the stove to bur n at its best efficiency,
t h e d o o r m u s t p r o v i d e a p e r f e c t s e a l w i t h t h e
f i r e b o x . T h e t i g h t n e s s o f t h e d o o r s e a l c a n b e
v e r i f i e d b y c l o s i n g a n d l a t c h i n g t h e d o o r o n a s t r i p
o f p a p e r. T h e t e s t m u s t b e p e r f o r m e d a l l a ro u n d
t h e d o o r. I f t h e p a p e r s l i p s o u t e a s i l y a n y w h e re ,
e i t h e r a d j u s t t h e d o o r o r re p l a c e t h e g a s k e t .
7.3.1 Adjustment
In order for the stove to burn at its best efficiency, the door must provide a perfect seal with the
firebox. Therefore, the gasket should be inspected periodically to check for a good seal. The
gasket seal may be improved with a simple latch mechanism adjustment:
1. Remove the split pin by pulling and turning it using pliers.
2. Turn the handle one counterclockwise turn to increase pressure.
3. Reinstall the split pin with a small hammer.
Figure 15: Removing the split pin
Figure 16: Installing the split pin
