Operation - 16
EDGER SETUP & CONFIGURATION
Setup For Left Side Operation
The edger can be operated with the disc on the left
side of the edger as well as the right. To set up edger
for left side operation:
1. Remove the two ball pins (A) from the frame
receiver tube and remove both the gauge
wheel assembly and the disc frame assembly
from the edger.
2.
A
Insert the gauge wheel assembly into the right
side of the frame receiver tube and secure with
the ball pin.
3. Insert the disc frame assembly into the left side
of the frame receiver tube and secure with the
ball pin.
NOTE: the disc position will be opposite from
its previous position on the right side of the
edger (i.e. if the disc was positioned in front of
the frame receiver tube while mounted on the
right side of the edger, it will now be positioned
behind the frame receiver tube).
Refer to the Disc Position Setup section for
instructions on rotating the disc to the front or
rear of the receiver frame tube.
