SAFETY
Safety - 11
General Safety Procedures
for Ventrac Power Units, Attachments, & Accessories
Operating On Slopes
•
Slopes can cause loss-of-control and
tip-over accidents, which can result in
severe injury or death. Be familiar with the
emergency parking brake, along with the
power unit controls and their functions.
•
If power unit is equipped with a fold down
roll bar, it must be locked in the upright
position when operating on any slope.
•
Use low range (if equipped) when operating
on slopes greater than 15 degrees.
•
Do not stop or start suddenly when operating on slopes.
•
Never shift between high and low range while on a slope. Always move the power unit to level ground
and engage the parking brake before shifting range or placing the power unit in neutral.
•
Variables such as wet surface and loose ground will reduce the degree of safety. Do not drive where
machine could lose traction or tip over.
•
Keep alert for hidden hazards in the terrain.
•
Stay away from drop-offs, ditches, and embankments.
•
Sharp turns should be avoided when operating on slopes.
•
Pulling loads on hills decreases safety. It is the responsibility of the owner/operator to determine loads
that can safely be controlled on slopes.
•
Transport machine with attachment lowered or close to the ground to improve stability.
•
While operating on slopes, drive in an up and down direction when possible. If turning is necessary
while driving across slopes, reduce speed and turn slowly in the downhill direction.
•
Assure a suffi cient supply of fuel for continuous operation. A minimum of one-half tank of fuel is recommended.
Roadway Safety
•
Operate with safety lights when operating on or near roadways.
•
Obey all state and local laws concerning operation on roadways.
•
Slow down and be careful of traffi c when operating near or crossing roadways. Stop before crossing
roads or sidewalks. Use care when approaching areas or objects that may obscure vision.
•
If there is doubt of safety conditions, discontinue machine operation until a time when
operation can be performed safely.
•
When operating near or on roadways, have a Slow Moving Vehicle Emblem clearly
displayed.
Truck Or Trailer Transport
•
Use care when loading or unloading machine into a truck or trailer.
•
The parking brake is not suffi cient to lock the machine during transport. Always secure the power unit
and/or attachment to the transporting vehicle.
•
Shut off fuel supply to power unit during transport on truck or trailer.
•
If equipped, turn the battery disconnect switch to the Off position to shut off electrical power.
