B-4
SAFETY
Gen eral Safety Pro ce dures
for Ventrac Trac tors, At tach ments, & Ac ces sories
Read and understand the operator’s manual before operating this equipment.
Observe and follow all safety decals.
DO NOT let children or any untrained person operate the tractor or attachment. Make sure
that all operators of this equipment are thoroughly trained in using it safely.
Never allow additional riders on the tractor or attachments.
DO NOT operate tractor or attachments if you are under the influence of alcohol, drugs, or
medication that may impair judgment or cause drowsiness, or if you are not feeling well.
Operate all controls from the operators seat only.
Before operating equipment, make sure all shields are in place and fastened.
Ensure the attachment or accessory is locked or fastened securely to the tractor (power unit)
before
operating. See tractor manual for locking procedure.
Ensure that all bystanders are clear of the tractor and attachment before operating. Be
especially careful and observant if other people are present. Never assume that bystanders
will remain where you last saw them.
Always look in the direction the tractor is moving.
Never direct the discharge of any attachment in the direction of people, animals, buildings,
vehicles, or objects of value.
Stop operation immediately at any sign of equipment failure and correct the problem before
continuing to operate. An unusual noise can be a warning of equipment failure or a sign that
maintenance is required.
Before adjusting, cleaning, lubricating, or changing parts on the tractor or attachment, engage
the parking brake, lower the attachment to the ground, stop the engine, and remove the
ignition key.
To prevent the risk of uncontrolled equipment movement on tractors equipped with 2 speed
axles, always shift the transaxle range with the power unit stationary on level ground and with
the parking brake engaged.
If equipment is to be left unattended, engage the parking brake, lower the attachment to the
ground, stop the engine, and remove the ignition key.
Summary of Contents for VR300
