21
www.ventilation-system.com
TEMPERATURE SETTING
To modify the temperature setting set the cursor at “Setpoint” by using the
button. Then use the
and
buttons to set
the desired temperature value and then press the
to confirm.
Temperature setting range: from +15 °C up to +30 °C.
FAN SPEED SETTING
To select the desired fan speed set the cursor at “Fan speed” by using the
button. Then use the
and
buttons to set the desired
value and then press the
to confirm.
Three fan speed stages are available: Low, Medium, High. The fan rotation speed corresponding to each speed stage is set as a percentage
of the maximum capacity of each fan via the unit parameter setup menu.
UNIT PARAMETERS
To enter the user parameter menu press the
button. Use the
and
buttons to select the desired menu item and press the
button to enter.
1. System information
To view the system information enter the user parameter menu and
select “System info”.
The “System info” menu consists of three pages. To navigate be-
tween the pages use the
and
buttons.
Page 1/3 contains the following parameters:
•
Current supply fan speed [%]
•
Current exhaust fan speed [%]
•
The current state of the heat exchanger:
On - heat exchanger enabled
Off - heat exchanger disabled
•
Current level of opening of the heat medium regulating valve
[%].
•
Current status of preheating enable signal:
On - preheating allowed
Off - preheating denied
•
Current status of the cooler enable signal:
On - cooler operation allowed
Off - cooler operation denied
On - the pump is turned on
Off - the pump is turned off
