www.ventilation-system.com
19
Page 2/3 contains the following parameters:
•
Outside air temperature [°C]
•
Supply air temperature [°C]
•
Exhaust duct temperature [°C] When selecting «Main sensor: in th-
Tune» in the «Parameter» fi eld.
•
Room temperature [°C] When selecting «Main sensor: in th-Tune» in
the «Parameter» fi eld.
•
Humidity in the exhaust air duct.
•
The level of air parameter in premises (%) when the outdoor air
parameter sensor is connected. (When connecting the outdoor
humidity sensor 0-10 V the readings will display the humidity level
(%) at the installation location of the sensor).
Page 3/3
contains the controller fi rmware information.
2. Time and scheduled operation
To set the clock and operation schedule enter the user parameters menu
and select
«Set time & scheduler»
.
The
«Set time & scheduler»
menu consists of four pages.
To navigate between the pages use the
and
buttons.
Attention! With the th-Tune control panel connected the scheduled
operation is set via the control panel!
Page 1/4
enables setting the unit operation schedule.
Press
to select the desired parameter and then set its value using
and
.
Schedule setup. This mode can be enabled only from the pGD1 control panel.
When using th-Tune the schedule is set up according to the th-Tune control panel description.
1. Day selection.
Use the
button to select the «Day» parameter and then use the
and
buttons to select the day for setting the schedule.
2. Setting the schedule recording start time.
Press
to start setting the fi rst entry. Then use
and
to adjust
the hour for the start of operation according to the fi rst entry.
After that press the
button to set the time in minutes and then use
the
and
buttons to set the minute value.
Summary of Contents for VUTR 200 V2 EC A17
Page 28: ...V140 1EN 01...
