10
VUTR 250/350/650 P/P2/PE/P2E EC
www.ventilation-system.com
width not more than 12.5 mm.
While installing the unit, ensure convenient access for subsequent maintenance and repair. Fasteners for ceiling mounting are not
included into delivery set and should be ordered separately. While choosing fasteners consider the material of the mounting surface
as well as the weigh of the unit, refer to the “Technical data” section. Fasteners for unit mounting should be selected by the service
technician.
HUMIDITY SENSOR MOUNTING
The humidity sensor is not included in the delivery set and should be ordered separately. It must be installed in the exhaust duct
upstream of the heat exchanger.
Undo the screws on the service panel and remove it. Screw the humidity sensor to the exhaust air duct wall. Connect the humidity
sensor connector to the cable of the control unit (installed by the manufacturer).