SPREADER SETUP & INSTALL KITS
Setup - 17
4. Install the spreader control box bracket onto
the control box mount using 2) #10-32 x 1/2”
machine screws and #10-32 flange nuts.
5. Fully extend the control box mount arm and tighten
the knobs to clamp the control box mount in place.
6. Connect the battery/
controller wire harness
to the positive and
negative wires con-
nected to the power
unit battery. Connect
the harness to the
battery lead on the
spreader controller.
7. Connect the motor/controller wire harness to the
motor lead on the spreader controller. Connect the
harness to the power cord on the spreader. NOTE:
if the power unit is equipped with a 3 point hitch,
route the harness down between the power unit
seat box and the pivot shaft on the 3 point hitch
before connecting to the spreader’s power cord.
8. Use Velcro ties to fasten both wire harnesses
to the arm of the control box mount just behind
the controller and also to fasten the harnesses
together, but not to the control box arm, about
halfway back to the roll bar.
9. Leave a small amount of slack in the wire harnesses
and use Velcro ties to fasten the harnesses to the
roll bar just below the frame mount bracket and right
above the power unit fender as shown above.
10. Coil the extra wire of the motor/controller har-
ness at the corner of the right fender and use a
Velcro tie to fasten both harnesses to the power
unit seat box. Fasten the coils of the motor/con-
troller harness together using a Velcro tie.
11. Coil the extra wire of the battery/controller har-
ness at the corner of the left fender and use a
Velcro tie to fasten to the power unit seat box.
12.
Fuse Holder
Fuse Holder
Install the circuit breaker into the fuse holder of
the positive wire as shown above.
Installation is complete.
Power Unit With KW350 Cab
1. Remove the tunnel cover from the lower rear
frame of the power unit.
2. On KW350 cabs with serial numbers 1001-1060,
a mounting hole must be drilled in the dash tray
of the bottom windshield mount. Measure
2-11/16” in from the inside of the rear lip and
5-1/2” in from the inside of the right lip.
5-1/2”
5-1/2”
2-11/16”
2-11/16”
