SPREADER SETUP & INSTALL KITS
Setup - 24
7. Coil any extra wire and use a zip tie to fasten to
the clamp on the inside of the rear frame under-
neath the radiator.
8. Route the battery/controller harness back along
the power unit’s rear wire harness and up beside
the electrical panel. Route the harness on top of
the engine, following the engine harness to the
engine ground location, then follow the negative
battery cable toward the battery.
9.
Fasten both
Fasten both
harnesses here
harnesses here
Fasten both wire harnesses to the power unit’s
wire harness on the rear frame using a zip tie
as shown above. Fasten the battery/controller
harness to the alternator bracket, the engine
harness, and the lift plate at the engine ground
location using 3) zip ties as shown above.
10. Connect the battery/controller harness to the
positive lead from the battery and the negative
lead from the engine ground and use a zip tie to
fasten the harness and the negative wire assem-
bly to the negative battery cable.
11. Install the circuit breaker into the fuse holder on
the positive wire harness.
12. Connect the negative battery cable to the battery.
13. Reinstall the power unit’s tunnel access cover.
14. Reinstall the power unit’s right rear frame cover,
if equipped with sound insulation panels.
SS300 Spreader Setup
1. Install the spreader pivot hitch onto the spreader
using 4) 1/2” x 1-1/4” bolts and 4) 1/2” flat wash
-
ers. Use Loctite 242 or equivalent thread locker
on bolts. Torque to 45 ft-lbs (61 Nm).
2. Install the spreader pivot hitch onto the tractor
pivot hitch and align the holes in the spreader
pivot plates with the hole in the tractor pivot tube.
Place 2) 5/8” flat washers onto the 5/8” x 4-1/2”
bolt and insert in the pivot
plates and tube. Place 2)
5/8” flat washers onto the
bolt and fasten with a
5/8” lock nut. Tighten
until snug, without
restricting the pivot
function of the hitch.
