- E9 -
SETTING THE SLEEP TIMER
1. Press the SLEEP button while the power is
on. "SLEEP 90" lights in the display.
2. Press and hold the SLEEP button to select the
length of remaining time until the unit turns off.
It changes the indicator in the following way:
SLEEP 90
SLEEP 80
SLEEP 10
........SLEEP 20
The Sleep Timer is set and the SLEEP indicator
lights in the display. Let go when required sleep
time (in minutes) is shown.
To cancel the sleep timer, press the SLEEP button
once and "SLEEP" will go out in the display.
SLEEP
MANUAL TUNING
The system can store a total of 40 stations. (Each band has a maximum of 20 available preset
stations). Presetting allows you to tune into a station directly. Stations are assigned preset numbers,
beginning from 1 in consecutive order for each band (AM and FM).
TO RECEIVE THE FM BROADCAST IN STEREO
Set the FM MODE selector to FM STEREO.
When the FM stereo broadcast is received, FM STEREO indicator lights up.
IF THE FM STEREO BROADCAST SIGNAL IS WEAK
Set the FM MODE selector to FM MONO.
Background noise will be reduced but the signal reproduced will be mono.
TO SEARCH FOR A STATION QUICKLY
Hold the TUNING UP or DOWN button and station searching starts automatically. When a station is
found, searching stops automatically.
However, it may not stop if the signal is weak. In this case, search for the station manually.
Note:
The last station tuned in will be recalled, even after changing the tuning band or the function, or after
turning the power off.
After use:
Press the POWER button.
1. Press the FUNCTION but-
ton to TUNER, the "TUNER"
appears on the display.
3. Tune into a station. "STEREO"
will appear when an FM
broadcast is in stereo.
2. Press the BAND button to
select the desired band.
2088_eng2.PMD
10/29/2004, 2:55 PM
9
Summary of Contents for CD2088
Page 1: ......
