EN
EN - 4
SySteM connectionS
SPeaKer connectionS
Connect the speakers to the R terminal and the L terminal.
note :
Connecting speakers other than the speakers supplied with the unit may damage the unit.
cautionS:
• Ensure that the power supply in your house complies with that indicated on the identification sticker located
on the back of your unit. (AC 120V ~ 60Hz).
• If you are not going to use the unit for a long time, disconnect the AC power plug from the wall outlet.
• This unit is designed for continuous use. Switching off the unit to standby mode does not disconnect it
from the power supply. To completely isolate the equipment, remove the plug from the wall outlet as some
components remain connected to the electrical supply.
• To prevent electrical shock, match wide blade of plug to wide slot of wall outlet, then fully insert.
You can charge your smartphone/tablet through the USB socket with a USB cable (not supplied).
Connect a USB cable (not supplied) to the USB socket on the front of the unit and the dock connector on your
smartphone/tablet.
cHarGe your SMartPHone/taBLet
Line in connection
You can connect audio devices such as your CD player or MP3 player to the unit via the LINE IN jack. To do this,
connect an audio cable from the line out or headphone out jack of the other audio device to the LINE IN jack on
the front of unit. Press the
Source
button to switch to AUX mode.
note :
We recommend you unplug the device from the LINE IN jack when not in use.
Setting the clock can only be done in STANDBY mode.
• If the unit is plugged in with the supplied AC adapter and the unit is in standby mode.
1. Press and hold the
/ProG/MeM
button until the hour digits blink.
2. Press the
or
button to adjust the desired hours and press the
/ProG/MeM
button once to confirm,
then the minute digits blink.
3. Press the
or
button to adjust the desired minutes and press the
/ProG/MeM
button once to start
clock.
cLocK SettinG
Press the
Source
button to switch to TUNER mode.
Searching for a Station automatically
• Press and hold the
or
button until the tuner starts searching for a station, then release. After tuning in
a station, the search stops.
Presetting Stations
1. Tune in to a desired station. Press the
/ProG/MeM
button.
2. The preset number will blink and the “MEM” indicator will be shown on the display.
3. Press the
or
button to select the preset number.
4. Press the
/ProG/MeM
button again to store it in memory.
tuning in to a Preset Station
Press the
/MeM.uP
button to select a preset number.
note :
Fully unwind the wire antenna. Then extend the wire antenna and place it in the position that sounds best.
When the reception is good, the “
” icon will appear on the display.
LiSteninG to tHe raDio
BWA17AA005_IB_r.indd 4
2017/1/17 14:42:09
