Venturer KLR33688B, User Manual

EN - 

FR -

 3

tooLS needed: 

1) Electric drill with 1/4” bit; 

2) Phillips-head (cross style) screwdriver.

SteP 1

If your cabinet does not have an overhang:

a) Place the Mounting Template in the desired location 

inside or underneath the cabinet (whichever has less 

obstructions, and will be easier for you to reach to drill 

holes),  flush  with  the  front  edge  of  the  cabinet  and 

tape it down.  Go to STEP 2.

If your cabinet doeS have an overhang:

a) Measure  the  thickness  “T”  of  the  cabinet  overhang 

(see Figure 1).

b) Fold the Mounting Template along the guideline that 

is closest to the thickness of your cabinet overhang.

c) Tape Mounting Template to the underside of the 

cabinet with the folded portion of the Mounting 

Template flush up against the cabinet overhang (see 

Figure 2).  Go to STEP 2.

SteP 2 

Use an electric drill with a ¼” drill bit (not included) to drill 

all three holes marked on the Mounting Template (see 

Figure 3). To reduce splintering, place a small piece of 

masking tape over each hole location before drilling.  Go 

to STEP 3.

SteP 3

If your cabinet does not have an overhang:

a) SIX screws are included with this unit, but you will 

only  need  three  of  them.  Select  the  screw  length 

which will go completely through your cabinet bottom, 

and provide at least 3/8” of thread to screw into the 

unit.

b) Insert the three selected screws through each hole 

from the inside of the cabinet going down (see Figure 

4).

Warning:

Please follow the steps below for proper mounting:

1.  We  recommend  you  install  the  3  screws  using 

hand tools. Do not use power tools because high 

torque can damage the threads on the main unit.

2. Please hold and support the unit before you insert 

any of the screws.

3.  First  mount  2  screws  on  opposite  corners  of  the 

unit.

c) Hold the unit up against the bottom of the cabinet, and align the three holes on the top of the unit 

with the screws. Partially tighten each screw, but do not fully tighten the screws until all of them 

have been started.

d) Gently tighten each screw until they are firmly holding the unit in place.

mounting Instructions