13
VTS reserves the right to implement changes without prior notice
Ventus Air Handling Units
-
The required installation place area:
-
Width of the unit + 4 meters (two meters on each side of the
unit)
-
Length of the unit + 4 meters (two meters on each side of the unit)
-
Base of the unit made in compliance with the requirements described in chapter 4.2.2.
-
The 230V power supply should not be located further than 20m from the installation place
which should be properly lit.
-
The place of installation shall provide a safe environment for the installation crew.
And additionally the following should be provided:
-
Availability of individual AHU elements or pallets including packages on the assembly place of
a particular AHU. Ensured transport of AHU elements and AHU blocks to the place of installation.
- A possibility of service entering the site and starting assembly immediately after their arrival.
- making the Warranty Card and Delivery documents supplied with a particular AHU available to
the service.
Assembly completion
After the installation is completed the service is obliged to:
- notify the client’s representative about the fact of finishing assembly.
- put into service a clean AHU labelled with provided pictograms and VTS labels, ready to be
connected to a power source (wiring), utilities and control systems,
- Hand control elements over to the client’s representative if at his request they were not
assembled in the AHU,
- Hand a filled in Warranty Card of a VTS AHU over to the Client
- hand the ‚Assembly Acceptance Protocol’ documentation to be signed by the client and provide
them with a copy of this document,
- put assembly waste in a place indicated by the client’s representative not farther than 20 meters
away from the place of assembly,
- Leave the assembly place in the state from before the assembly
VTS on-site assembly does not include:
a. Setting up of electrical wiring, connection to heating of freezing sources and assembly of
exchanger valve,
b. Connection, assembly and start-up of control elements (except for damper actuators, pressure
control and anti-frost thermostat) and engines zeroing,
