Vera Control VeraSecure, Quick Start Manual

Advanced Z-Wave Functions

Get network update from SUC/SIS 

This option will update the slave controller network from the 
primary controller to which it’s currently added. This option is 
used when Vera is a secondary controller.

Backup Z-Wave Network 

VeraSecure has the ability to back up its Z-Wave network and its 
configuration settings to be restored on another gateway. 
This procedure is explained on the page below:

http://support.getvera.com/customer/portal/articles/2345058

Reload Engine 

Reloads the Lua engine.

Update Neighbor Nodes 

This forces the controller to do a node neighbor update over 
Z-Wave for all the nodes in the network.

Learn Mode 

Include your controller into an existing Z-Wave network. 
Steps for VeraSecure controller using the web interface.

Click on Settings > Z-Wave Settings > Advanced > Select 
‘Copy Z-Wave network from a primary controller’

This will put the controller into learn mode and shift it to 
a secondary role. The controller can now receive data from a 
primary device in the network and associate with other devices 
in the Z-Wave network via the primary controller.

Replication 

Include another controller and transfer the Z-Wave network 
data to it. Steps for VeraSecure controller using the web 
interface.

Click on Settings > Z-Wave Settings > Advanced > Select ‘Controller Shift’

All the Z-Wave devices will be replicated into the new controller. 
This is used to transfer data from one controller to another. 
With replication the new controller becomes primary.

E

E

F

G

H

F

Figure 3-1:

 Advanced Tab

G

H