I-Ga te 4000 P R O Ins tall ation
Inserti ng the Ca rds
02041802-05
Veraz Networks Inc. Proprietary
8-9
8.5. Inserting the Main Cards
Warning
: Before connecting the I-Gate 4000 PRO to the PDU (-48VDC)
ensure that the relevant circuit breaker is in the OFF position. Insert the PEFD
and PEFU cards. Switch on the circuit breaker and verify that the 'PWR IN'
LEDs are lit.
To insert a Main card:
1. Remove the four fasteners that secure the I-Gate 4000 PRO front lower panel to
the chassis. Do not use pliers; the fasteners should only be tightened or loosened
by hand.
2. Swing the front panel open and allow it to hang on its hinges. Although the front
panel may be lifted from its hinges, it is not necessary to remove it for this
procedure.
3. Align the card with the slot appropriate for the functionality of the card, as
shown in Figure 8-5.
4. Slide the card straight back into the slot until the PCB ejectors click into place,
and the card is secure (see Figure 8-5). The card is secure when you cannot pull
it out without lifting the PCB ejectors.