Please note that the Over-Temperature Menu is only available when the Over-
Temperature Protection option is fitted.
3.2.3
Basic Function Guide
HOLd
Used to pause the current program and set new parameters.
SP"C
Used to set the desired temperature (setpoint) of the product
(°C).
SPrr
Used to set the heating rate of the product, e.g. increase by
5°C per minute.
t1
,
t2
,
t3
,
t4
,
t5
Indicates the timer type in use. See section 3.5 for more
details.
t.typ
Used to set the timer type.
t.bnd
Available when
t1
or
t4
is in use. Allows the timer to start
the countdown before the desired setpoint is reached.
rSt
Used to reset the timer.
OPHi
Used to set the maximum output power.
CL.St
Used to set the customer calibration type.
FAct
Used to select the factory calibration settings.
PASS
Flashes when a password is required to access further
options.
C.CL1
Select to access the single point calibration option.
C.CL2
Select to access the dual point calibration options.
OFSt
Used to set the single point calibration offset temperature
(°C).
CAL.L
Used to set the low temperature point (°C) for dual point
calibration.
CAL.H
Used to set the high temperature point (°C) for dual point
calibration.
OFS.L
Used to set the offset value for the low temperature point
(°C) for dual point calibration.
OFS.H
Used to set the offset value for the high temperature point
(°C) for dual point calibration.
Ot
Used to set the Over-Temperature limit (°C).
Ott
Displayed when the Over-Temperature protection has been
activated.
PV
Displayed before the current temperature when checking the
Over-Temperature sensor temperature.
17
3.0 301 Controller
