VC4000 Manual
39
Figure 15: VC4000 back panel
(PC) Turn on external sensors if using them
Each GPS or VSI sensor must be turned on for the VC4000 to record
data from it.
1. Press the Tools key
2. Scroll to
Setup
and press
ENTER / YES
3. Scroll down to
Sensors…
and press
ENTER / YES
4. Choose OBDII Sensors or GPS Sensors and press
ENTER /
YES
5. See Setup, Sensors on page 73 for details on each sensor
6. Press
CLEAR / NO
twice to get back to the READY screen
Or use
Profile
to change the setup in the VC4000 from your PC:
1. Start the Profile program
2. Connect the VC4000 to your computer
3. Turn on the VC4000
4. In Profile, Click on the VC4000 Setup icon (or Tools/VC4000
Setup)
5. Profile will connect and retrieve the VC4000 setup
6. Turn on the sensors using the tabs for each section
7.
Click the “Send Setup” key
VC4000 Run Storage Memory
The VC4000 stores all braking runs to internal
flash memory
.
Eventually the memory will fill up or the number of files will exceed
9,999. When this happens you will have to clear memory. The
display will prompt you to clear memory after the error message
appears. You should clear run data memory
periodically
to ensure
data storage is successful. To clear memory, press the
CLEAR / NO
key from the “READY” screen and follow the prompts. Monitor and
