T
o
o
ls
VC4000 Manual
48
Data to monitor are:
G-Force
– X, Y and Z axis + peaks
OBDII Sensors (PC)
GPS speed, location and altitude (PC)
(PC) GPS and OBDII Sensors must be turned on to monitor. To
store the data of the sensors, those sensors have to be turned on in
Setup. See “Setup/Sensors…” for details on turning individual
sensors on.
Start Monitor mode:
1.
From the “READY” screen press the
3
Tools
key.
2. Select
Monitor
.
a. PC Version - Choose the sensor to show on the
screen.
3. Press
ENTER / YES
to save the data to memory or
CLEAR /
NO
to display without saving.
Storing Data while monitoring
There are two ways to store the data:
1. Start monitor mode on the VC4000 and choose to save in
internal flash memory.
2. (PC) Start Data Streaming from Profile and store the data to
your computer’s hard drive.
If you choose to save the data, the X, Y and Z axis
accelerometers
are always stored
when saving to memory regardless of which
sensor is being displayed. Any sensors that are turned on will also
be stored, regardless of whether it is being displayed or not.
The Monitor mode limits are about 115 minutes if only the
accelerometer data is being stored, or use this formula to calculate
the time in seconds if more sensors are turned on:
G-Force
GPS
OBDII
