VC4000 Manual
67
All VC4
000’s have a date chip that maintains time and date even in
the absence of power. It contains a
lithium battery
supply, which
will last a minimum of 10 years. The time and date of each run is
stored in memory and then uploaded to Profile and stored in the
header of Profile for each run. This is useful if the file numbers do
not correlate to the test number because you have had to clear
memory after making some tests. At least you have the time of day
for a reference point.
1. Select
Date/Time
from the Setup menu
2. Set the time for your time zone by entering every number,
including zeros. To enter time of 9:00 enter 0, 9, 0, 0.
3. Enter 1 for am or 2 for pm after the digits are entered.
4. Enter the date including zeros. After the date is entered the
VC4000 sets the time and date in memory.
5. Alternatively use
Profile
to set the time and date to your
computers time and date.
CLEAR / NO
may be pressed anytime to abort setting the time and
date.
Enter the pitch and roll factors. The default is 1 for each. Pitch is the
front-to-back tilt, and roll is the side-to-side tilt. If G summation is
either 2D (XY) or 3D (XYZ) the VC4000 will use the Gx pitch factor
for the adjustment. Gy (roll) and Gz adjust will have no effect.
Date/Time
Pitch/Roll Factors
