Button sewing
05
1
1
1
Please Note:
When you finish the work, move the
drop feed control to raise the feed dogs.
Raised position
1
Change the presser foot with the button
sewing foot.
Move the drop feed control to lower the
feed dogs.
Lowered position
Position the work under the foot. Place
the button in the desired position, lower
the foot.
Select zig-zag pattern. Adjust the stitch
width to "2.5-4.5" according to the
distance between the two holes of the
button.
Turn the handwheel to check that the
needle goes cleanly into the left and
right holes of the button.
If a shank is required, place a darning
needle on top of the button and sew.
Pull end of the upper thread to the
reverse side of the fabric, then tie it with
the bobbin thread.
For buttons with 4 holes, sew through
the front two holes first, push the work
forward and then sew through the back
two holes.
51