Figure 1-4
NetBackup 5240 Appliance control panel
E
F
G
A
D
B
C
H
Table 1-4
NetBackup 5240 Appliance control panel LED descriptions
Description
Component
Label
The System ID button toggles the integrated ID
LED and the blue server board LED on and off.
The system ID LED identifies the system for
maintenance when the it is racked with similar
server systems.
See
on page 14.
System ID button with
integrated LED
A
When it is depressed, the NMI button puts the
appliance in a halt state, issues a non-maskable
interrupt (NMI), and then triggers the non-maskable
interrupt. All server data can be lost.
Veritas recommends that you do not enable NMI
by pressing the NMI button.
NMI button (recessed, tool
required for use)
B
The front control panel includes two activity LED
indicators for each on-board network interface
controller (NIC). NIC-5 represents network interface
controller 5, while NIC-6 represents network
interface controller 6.
When network links are detected on the controllers,
the LEDs are activated and remain on. The LEDs
blink when network activity occurs, and the rate at
which they blink is determined by the amount of
network activity that occurs.
NIC-5 Activity LED
NIC-6 Activity LED
C
H
When depressed, the System Cold Reset button
re-boots and re-initializes the appliance.
System Cold Reset Button
(recessed, tool required for
use on non-storage models)
D
13
About the NetBackup 5240 Appliance
NetBackup 5240 Appliance control panel
