CopyDisc Duplicator Series
11
IMPORTANT:
The CopyDisc XC uses three input baskets/spindles in order to accomplish the 660 disc capacity.
The media is moved from spindle to spindle via the printer in a specific cycle and it is therefore
essential that certain rules are followed in order to achieve perfect operation.
Normally the input baskets/spindles can only be replenished with new media at the end of a
spindle cycle and not at the end of or part way through a job.
The input spindles must not be replenished with new media part way through a spindle cycle
unless the power is removed from the CopyDisc XC thus re-setting the spindle cycle.
The CopyDisc XC will halt any job in the event of detecting an empty third input spindle. At this
point, if the job is finished, the processed media may be removed, the spindles replenished
with new media and the job re-started.
If the job is not complete and the requested number of copied discs has not yet been fulfilled,
the LCD display will display
Input Hopper Empty
. Select
Cancel
if you do not wish to
continue with the job. Otherwise by selecting
Continue
the CopyDisc XC will continue, first
looking to the first spindle for blank discs, then the second and finally the third. It is important
therefore to replenish the correct spindle(s) before continuing.
Not all input spindles need to be used but they should be used in sequence 1, and 2, and 3.
The input spindles do not have to be filled to capacity.
The initial output spindle should always be empty when starting a new job.
