FiOS Router User Manual
87
© 2009 Verizon. All Rights Reserved.
Routing
Routing Mode
Select one of the following two Routing modes:
Route
•
- Select this option to cause the FiOS Router to act as a router between
two networks.
NAPT
•
- Select this option to activate NAPT (Network Address and Port
Translation), which refers to network address translation involving the
mapping of port numbers and allows multiple machines to share a single IP
address. Use NAPT if the local network contains multiple devices, a topology
that necessitates port translation in addition to address translation.
Device Metric
The device metric is a value used by the FiOS Router to
determine whether one route is superior to another, considering parameters
such as bandwidth, delay, and more.
Default Route
Click in this check box to define the connection as a the default
route.
Multicast - IGMP Proxy Default
Click in this check box to enable the FiOS
Router to issue IGMP (Internet Group Management Protocol) host messages
on behalf of hosts the FiOS Router discovers through standard IGMP interfaces.
IGMP proxy enables the routing of multicast packets according to the IGMP
requests of local network devices asking to join multicast groups.
Internet Connection Firewall
Enable or disable the firewall for this interface. It is recommended to keep the
firewall enabled for all of the FiOS Router’s connection interfaces.
Additional IP Addresses
Click
New IP Address
to generate the “Additional IP Address Settings” screen,
where additional IP addresses can be created to access the FiOS Router via the
connection.
