030-300505 Rev. A
141
April 2007
User Guide
VersaLink Wireless Gateway (Model 327W)
15.15
Private LAN—Configuring NAT
In the
Advanced
screen
,
click
Private LAN
.
The following screen will appear. Private LAN allows you to set up a
network behind your Router.
If you change the settings in this screen, click
Apply.
If you click
Reset
, the screen will refresh and the previously
saved settings will remain active.
IMPORTANT:
Whenever you change the settings in a screen, the screen will display the changes; however, you must
click
Apply
to allow the changes to take effect in the Router. (
Private LAN
is the default setting for VersaLink.)
Private LAN
Private LAN DHCP Server Enable
Default = Enabled
If this box contains a check mark, this enables DHCP addresses to be
served from the Private LAN pool.
Private LAN Enable
Default = Enabled
If this box contains a check mark, this enables the addresses from the
Private LAN to use the NAT interface.
Modem IP Address
Displays the Router’s IP address.
Subnet Mask
Displays the Subnet Mask, which determines what portion of an IP
address is controlled by the network and which portion is controlled by the
host.
DHCP Start Address
Displays the first IP address that the DHCP server will provide.
DHCP End Address
Displays the last IP address that the DHCP server will provide.
DHCP Lease Time
Displays the amount of time the provided addresses will be valid, after
which the DHCP client will usually resubmit a request.
