030-300505 Rev. A
142
April 2007
User Guide
VersaLink Wireless Gateway (Model 327W)
Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.
If the settings you have entered in the
Private LAN Configuration
screen are incorrect, the following warning
messages may be displayed in pop-up screens. If this occurs, check the settings in the
Private LAN Configuration
screen.
Warning Message
Check Private LAN DHCP Settings
Start Address is not part of the Subnet
Check the value in the DHCP Start Address field
End Address is not part of the Subnet
Check the value in the DHCP End Address field
End Address is below the Start Address
Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds
Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59
Check the
Seconds
value in the DHCP Lease Time field
Minutes must be between 0 and 59
Check the
Minutes
value in the DHCP Lease Time field
Hours must be between 0 and 23
Check the
Hours
value in the DHCP Lease Time field
15.16
Public LAN—Multiple IP Address Passthrough
In the
Advanced
screen, click
Private LAN
. The following screen will appear. The Public LAN feature allows
VersaLink to use LAN IP addresses that are accessible from the WAN. Public LAN allows your computer to have
global address ability.
NOTE:
To utilize the Public LAN feature in your VersaLink, Verizon must support Public LAN and Static IP. If
you have questions about the feature, contact Verizon for details.
If you change the settings in this screen, click
Apply.
If you click
Reset
, the screen will refresh and the previously
saved settings will remain active.
IMPORTANT:
Whenever you change the Private LAN settings, the screen will display the changes; however, you
must click
Apply
to allow the changes to take effect in the Router. (
Private LAN
is the default setting for VersaLink.)
To enable Public LAN, click the
Public LAN DHCP Server Enable
box (a check mark will appear in the box).
