EUROBLOC
SERVICE MANUAL FOR HOIST
102/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
Adjust the holding brake limit switch (6) to be mechanically
activated by the cam of the detent arm, when the solenoid (8)
de-energized.
Adjust the latch rest position by moving the solenoid
attachment plate horizontally.
5
6
Check that the gap (t) between the detent arm (4) and the
brake rim (1) is within t = 1…2 mm when the hoist is idle.
When the solenoid is activated, check that there is a
clearance between teeth (5) and detent arm (4).
Manually activate the holding brake limit switch (6) pressing
the solenoid (8) in when operating in the down direction and
verify that hoisting is stopped in the down direction. The up
direction should continue to operate.
7.1.9.2 Maintenance of holding brake
1
2
Check that the drum brake and surrounding surfaces are free
from oil, grease, excessive dust and/or other substances that
may reduce the effectiveness of the friction material of the
drum brake.
Check that the solenoid (8) works properly.
