EUROBLOC
SERVICE MANUAL FOR HOIST
105/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Reassembly
1
2
Clean the mounting holes in the end plate and the detent arm
hole (3).Install the two sleeve bearing (15) in the detent arm
hole (3) using impact bushing and a rubber hammer.
If necessary, sharpen the detent arm teeth by grinding it
before installation.
Position the detent arm (3) with required number of washers.
The position depends upon the frame size. Brush a small
amount of installation oil in the end plate holes and install the
axle (14) When the top of the axle (14) is flush with the end
plate lock it into place with a screw (13).Tighten the screw
lightly.
3
4
Clean the rope drum holding brake surface thoroughly. Install
the brake rim halves (1) on the drum groove. Install the disc
springs (12) on the bolts (11) and screw the bolt into the brake
rim (1).
Tighten the two brake rims (1) together with the bolt (11) and
disc springs (12).
If there are two brake bands (1) ensure that the connection
points of the halves of both rims are not aligned, they must be
90 degrees apart.
Tighten the brake band bolts evenly with a torque 60 Nm.
Fix the support bars and install the end plate to the drum.
