EUROBLOC
SERVICE MANUAL FOR HOIST
107/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Remove the screw (13) locking the detent arm axle and
reinstall it after applying thread locking compound. Secure it in
place with a nut (19).
Mark a black dot on the follower wheel to verify rotation and
remove the screw holding the spring fixing plate to the end
plate.
Rotate the rope drum so that the follower wheel is placed on
the low point of the cam ring Adjust the spring length by
moving the fixing plate. Adjust the length for the
corresponding reducer type according to the dimensions given
in below table.
After the adjustment, install adequate number of washers
between the fixing plate and the end plate and lock it with bolt
(20)/(21).Write the adjusted spring length on the end plate.
Hoist reducer type
Spring length
(mm)
E
89…92
F
90…91
G
92…95
H
90
J
91…94
11
Install the limit switch (6) to the end plate with screws. Adjust
the limit switch trigger points so that the limit switch triggers
when the detent arm is 1…2 mm above the brake rim.
t = 1…2 mm.
Adjustment
