EUROBLOC
SERVICE MANUAL FOR HOIST
121/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Reassembly
1
2
Fit the limit switch (1) carefully in its place, so that the roller
lever is in correct position and in front of the limit switch fixing
plate. Tighten the fixing screws (3).
Reconnect the wires. Reassemble machinery cover and close
the connection box cover (2).
Note: Use self locking nuts for fitting the limit switch. Self locking nuts can be reused no more than 5 times.
3
4
Fasten the cables to the support using cable ties. Fasten the
machinery cover (5).
Switch ON the power supply to the hoist and check the proper
functioning of the limit switch.
CAUTION
In many cases it is necessary to readjust the limit switch. Be aware of
incorrect settings during testing the operation.
Adjustment
1
2
Lower the hook to approx. 100 mm above the floor.
Loosen the fixing screws (3). Move limit switch (1) along the
tie rod (4) until the limit roller lever switch is just activated.
