EUROBLOC
SERVICE MANUAL FOR HOIST
128/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Adjustment the white model with A/S motors
1
2
Lower the hook to approx. 100 mm above the floor.
Turn the screw “S4” until the limit switch “S4” is just activated.
Test the operation. The downward motion must stop at the
described distance.
3
4
Lower the hook to approx. 200 mm above the floor.
Turn the screw “S1” until the limit switch “S1” is just activated.
Test the operation. The downward motion must slow down to
Low speed at the described distance.
5
6
Raise the hook until it is minimum 100 mm below the specified
C-dimension, or minimum 100 mm under any fixed steel
structure.
Turn the screw “S3” until the limit switch “S3” is just activated.
Test the operation. The upward motion must slow down to Low
speed at the described distance.
7
8
Raise the hook until it is at the specified C-dimension, or
minimum 50 mm under any fixed steel structure.
Turn the screw “S2” until the limit switch “S2” is just activated.
Test the operation. The upward motion must stop at the
described distance.
