EUROBLOC
SERVICE MANUAL FOR HOIST
161/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Reassembly
1
2
Lubricate thrust bearing (3) and shaft of the hook (1).
Reassemble the thrust bearing (3) and the locking rings (4).
Insert the hook (1) into it. Insert this assembly into the cross
bar (5) and tighten with hand the fixing screws.
3
4
Reassemble the side plates (6) and the rope sheaves (8).
Install the shaft locking parts (9).
5
6
Ensure that the sheaves and the hook rotate freely before
tightening the bearing housing fixing screws and the shaft
locking screws to the required torque.
Raise the hook block. Carefully guide the rope with a gloved
hand until the hook block hangs free from the working
platform. Switch ON the power supply to the crane.
