EUROBLOC
SERVICE MANUAL FOR HOIST
199/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
Remove the fixing parts (5) (5A Snap ring or 5B Plate and
screw whichever applicable). Remove the trolley wheel
along with the bearing set by gently tapping the wheel with a
mallet.
Remove the snap ring in order to remove the bearing set (3)
from the trolley wheels (2).
Reassembly
1
2
Install the bearing set (3) in the travel wheel (2) with the
snap ring
Install the trolley wheel along with the bearing set by gently
tapping the wheel with a mallet. Install the fixing parts (5) (5A
snap ring or 5B plate and screw whichever applicable).
3
4
For driving load
Place the cap (7) and reassemble the cover plate (5) and fix
with screws.
Install the hoist on the runway. Switch ON the power supply
to the hoist and raise the hook off the ground.
7.3.6.2 Maintenance of under running (single girder) trolley wheels
CAUTION
Asymmetrical wear may indicate misalignment on wheels. If the wheels are
asymmetrically worn, measure the wheel alignment. Readjust if possible or
change the parts if necessary.