EUROBLOC
SERVICE MANUAL FOR HOIST
202/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
Remove screws and pull out bearing housing (4). Remove
the driven wheel (5) along with the bearing.
Remove the snap rings in order to remove the shaft set.
5
GTLRemove wheel (1) and pull out bearings (2) from wheels
(3) and (5).
Reassembly
1
2
Press bearings (2) into wheel, avoid pressing from inner ring.
Insert the wheels (3) and (5) including bearings into end
carriage.
Mount bearing housing (4) into end carriage and tighten
screws to the recommended tightening torques.
3a
4