EUROBLOC
SERVICE MANUAL FOR HOIST
70/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
Remove two screws in order to remove the joint plate (4).
Remove the lower half (2) of the guide frame from the drum
groove.
Remove two screws in order to remove the guide element (7)
from the hoist intermediate shaft and remove it from the upper
half (3) of the guide frame.
5
Remove the upper half (3) of the guide frame from the drum
groove.
Reassembly
1
2
Place the upper half (3) of the guide frame against the drum
groove. The correct groove is the first empty groove next to
the rope. Fix the joint plate (4) to the upper half (3) of the
guide frame with two screws. The edge that has the rounding
must point towards the rope fixing clamps.
Place the plastic guide element (7) over the intermediate shaft
and fix it to the upper half (3) of the guide frame with two
screws. The plastic part must be on the side of the rope fixing
clamps.