EUROBLOC
SERVICE MANUAL FOR HOIST
83/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
By keeping the halves yet together, turn the
gearbox around so that the gear housing half (3)
is now on top.
Detach the halves from each other. Be careful
with the shaft assemblies (4) inside the gearbox
when lifting the gear housing half (3), taking into
account the lip sealings (6).
Avoid spilling out the lubrication, keep it on the
cover (1) or collect it to a separate container.
Remove the paper sealing (5) and clean the
sealing surfaces in both gearbox halves. Check
that the surfaces are not damaged.
Add or replace the lubrication if necessary.
Ensure that the shaft assemblies (4) are properly
installed on the cover half (1).
Remove the lip sealings (6) from the bearing
housing half (3).
5
6
Install a new paper sealing (5) on the cover half
(1).
Reassemble the gearbox halves together.
Once the halves are attached to each other,
install the new lip sealings (6). Be careful with the
installation so that the sharp edges of the shafts
do not damage the new sealings.