EUROBLOC
SERVICE MANUAL FOR HOIST
87/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
3
4
Uninstall the encoder support (A) by removing the screws and
the serrated washers.
Disassemble the coupling sleeve if necessary by removing the
screws and the sleeve from the motor shaft. Use pullout
screws if necessary; tighten the pullout screws little by little
until the sleeve comes off the motor shaft.
Reassembly
CAUTION
The encoder cable must not be installed in such way that it mechanically
causes load towards encoder.
CAUTION
The encoder cable must not be bent sharply, as in this way, the cable is easily
damaged.
CAUTION
The encoder cable must not be placed too close to the motor cables. The
recommended distance is 20 cm.