EUROBLOC
SERVICE MANUAL FOR HOIST
98/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Disassembly
1
2
Remove the three nuts and bolts (9) to remove the cover (10)
from the attachment plate.
Remove the screws (11) which hold the limit switch (6) to the
attachment plate.
Remove the screw (12) holding the lever (13) in the solenoid
shaft groove.
Remove the snap ring (14) and the washer (15) to remove the
lever (13) on the axle (7).
3
4
Remove the bolts (16), nuts and washers holding the
attachment plate with the bushing (17) in between the
attachment plate and the end plate. Remove the solenoid
assembly (8) from the attachment plate.
Remove the bolts (3) and disc springs (2) holding the brake
rim halves (1) together.
5
6
Remove the snap ring (18) and the washer (19) on the axle
(7) from the outer side of the end plate.
Remove the axle (7) with the snap ring (20) to remove the
stack of detent arm (4) and washers (21).
