EUROBLOC
SERVICE MANUAL FOR HOIST
99/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
7
If necessary, remove the bushing in the axle holes in the end
plate. Remove the spring pin (22) to separate the stack of
detent arm (4) pieces.
Reassembly
1
2
Take nine pieces of detent arm (4) and attach tightly against
each other using a spring pin (22).
Install the pin (22) so that the pin ends extend 1-2 mm past the
outmost locking latches.
Clean the holding brake installation hole thoroughly. Brush the
outside surface of the bearings (23) with thread-locking
compound.
Place the first sleeve bearing evenly on top of the upper axle
hole. Place the impact bushing on top of the bearing and
carefully tap the bearing into the hole with a hammer. Similarly
tap the second sleeve bearing into the lower axle hole.
3
4
Install the snap ring (20) on the axle (7).Position the detent
arm (4) as show in the illustration and adjust its position using
shim washers (21). Place 2 shim washer (21) below the snap
ring (20) on the axle (7). Guide the axle (7) through detent arm
(4).
Fit the shim washer (19) and the snap ring (18) on the axle (7)
from the other side of the end plate.
