STAGEMAKER®
-
6
VERLINDE reserves the right to alter or amend the above information without notice.
11/2008
3 Instructions for proper operation and maintenance.
,
Follow the instructions below in order to keep your equipment in good condition and to
keep your product safe
Never move or lift the hoist by the electric cables.
Do not set down the hoist without having an adapted support,
to avoid damaging the components on the underside (electric
cable, lifting chain, cable gland, chain bucket...).
Never modify the hoist unless the constructor has studied and
authorized the modification.
Never modify the values and adjustments of the safety
components, outside the limits provided for in the manual, or
without the approval of the constructor.
Never try to repair or modify the hoist without the
authorization of the constructor or a trained maintenance
agent.
Never block, adjust or remove the limit switches or stops
installed on the hoist without the authorization of the
constructor or a trained maintenance agent.
Never use the hoist to extract, loosen, or pull sideways.
Do not touch the moving components.
Do not operate the hoist if your physical condition does not allow it.
Never use the hoist when in bad repair (wear, deformation...).
Do not subject the hoist to brutal shocks.
Never use the lifting chain as a sling
Never use a hook other than in the vertical position.
Never distract the operator while the hoist is being operated.
Never leave a suspended load hanging, if it is not necessary.
Never use the hoist as an earth reference for welding.
Do not use the hoist for a purpose or in an area for which it is not intended.
If manually moving the hoist, push the load.
Do not use the safety components (end buffers, emergency stop,…) as operation components.
Do not use the controls needlessly (avoid inching - stop-start operation of the buttons). This can
cause overheating and even damage to the hoist.
Do not use the hoist with a power supply that is different to the one recommended (under-voltage or
over-voltage, absence of phase...).
Make sure that the hoist is always clean.
If manually moving the hoist, push the load
*
Material used outdoors should be
protected as well as possible
against bad weather conditions.
